Forum

Installation of Curecoin wallet remains inactive  

  RSS
Anthony Nash
(@anthony-nash)
New Member Customer

Hi all,

I have installed Curecoin-qt version 1.9.6.1-CURE on Linux Mint and after syncing and waiting two days I've yet to see any Curecoin transactions coming into my wallet. This is a replacement to my Mac 1.9.4, which had been receiving transactions up until three days ago when I last opened it. 

From the older Mac Curecoin wallet, I made a backup and copied that across to the fresh Linux installation. I can see an Address in the "Receive coins" frame so it is clear that the backup was loaded straight after the installation. I have a green tick plus 113 active connections. 

All I have done is install the wallet and copied across my latest wallet.dat - am I missing something fundamental? I suspect if I load my old wallet on my Mac, I'm going to receive two days worth of Cure. 

Thanks. 

ReplyQuote
Posted : 13/12/2018 4:37 am
Topic Tags
wuffy68
(@wuffy68)
Member Admin

Hello Anthony - can you share a receiver address ... we can test a small transaction. A few things come to mind - one is ownership/permissions on the .dat file now on your Mint system. If the .dat is read-only, that could cause similar behaviour.  -Wuffy68 

ReplyQuote
Posted : 14/12/2018 1:10 am
Anthony Nash
(@anthony-nash)
New Member Customer

Thanks for the reply. 

Three sets of permissions, I've changed them all and no change. Still halts at "Loading block index...". I even copied over a two-version old wallet from 1.? to 1.9.6, before then upgrading to 2.0. No change.

Here is a test address: BFy7spe4TgKwHMSfexReDj8ZBPcrN7whGk

ReplyQuote
Posted : 26/12/2018 5:46 am
Anthony Nash
(@anthony-nash)
New Member Customer

I've tried installing the latest QT on my Mac, that works fine! Although, with the odd Mac file system I am trying to figure out where the wallet.dat should go! 

ReplyQuote
Posted : 26/12/2018 6:02 am
Share:
  
Working

Please Login or Register